Details:
This is a very well specified Pultra 1750 lathe. I put this set together some time ago, intending to keep it for my personal use but, after over 2 years of not cutting metal - I realise I'll never really use it - so someone else should have the pleasure of using it.
The set consists of the lathe/motor unit, mounted on a wooden base, plus two (genuine Pultra) boxes of accessories.
The headstock has been stripped/cleaned and re-built (so may, possibly, require minor adjustment after 'bedding in'. It's got a 'lever action' tailstock and is driven by an electronically controlled, 550W, industrial sewing machine motor - capable of being adjusted between 100 and 4500 rpm (in increments of 100 rpm). Given the ratio of the pulleys, this gives a headstock speed of, approximately, 80 - 4000 rpm. There is also an, adjustable brightness, LED work light.
Box 1 of the accessories contains 57 'wire' collets, 8 large diameter collets, 4 cup-chucks, a 3-jaw chuck (Bernerd, with 'reversible' jaws), a 4-jaw chuck (brand new), a 'box chuck', a faceplate, a catchplate, a tailstock drill chuck, 'lantern' and 'block' toolposts, various centres (full, half and 'internal'), plus holders and various sized drive dogs.
Box 2 contains a compound slide and clamp bolt, tailstock and headstock riser blocks (increases the centre height), a 'flip-over' tool-rest, a rear tool-post mount and 'high' (for use with the riser blocks) and 'low' 'lantern' type toolposts.
Any questions - just ask!
Collection from 'Nawton' - about 25 miles North of York
Terms:
Price: £950.00
Collection Only
